Aluminium Alloys
Material requirements considered within a verified high-pressure aluminium die casting route—from drawing and engineering review to validation and serial production.
Start an RFQ- 01
- Cold chamberHPDC technology
- 02
- 6 HPDC cellsAutomated production
- 03
- 200–1,000 tPress range
- 04
- 20 g–10 kgCasting capability
Start with the drawing and available requirements.
RIVIMETAL evaluates component geometry and manufacturing requirements before production. The review considers feasibility and the manufacturing route, creating a practical basis for quotation, tooling and validation.
Drawing / project requirements
The verified project route begins with the drawing and information available for review.
Geometry / feasibility / route
Engineering and process review take place before production preparation.
Quotation / tooling / validation
The reviewed requirements support the next documented project stages.
Specify the required material with the RFQ.
The currently approved RIVIMETAL content does not publish individual alloy grades, EN designations, chemical compositions or mechanical-property tables.
Include the applicable material information with the project documentation where it is specified. No unverified alloy grade or performance value is presented on this page.
From material input to production approval.
The existing RIVIMETAL workflow connects material input with high-pressure die casting, production control and documented project approval.
- 01Melt ingots
- 02High-pressure die casting
- 03Casting quality control
- 04Trimming and finishing
- 05PPAP / FAI
- 06Serial production
Send your drawing and material requirements.
Receive a personalised quotation within 24 hours. RIVIMETAL engineers review every request in detail.